Post Your Requirement Menu

Welcome User

Other Products / Services

Our product range comtains a wide range of timber fixings, Timber Engineering Hardware, DT Driving Tool, HDA Holding Down Angle and SET2 Safety End Strip Tie

Timber Engineering Hardware

A comprehensive range of connectors produced from galvanised steel to bs en 10436:2009 +g275 as standard or stainless steel to order. Galvanised hangers must be fixed using 30 x 3.75mm sheradised square twisted nails in all pre-punched holes.

View Complete Details

timber fixings

Manufactured from galvanized steel to bsen 10346:2009 dx51d +g275 as standard, or stainless steel grade 304 (non-magnetic) to order.

View Complete Details

DT Driving Tool

This robust universal tool is designed to aid installation of 75x75mm and 100x100mm post spikes, to protect the shoe whilst hammering into the ground.

View Complete Details

HDA Holding Down Angle

A heavy duty general purpose angle plate manufactured from 2.5mm thick galvanised steel to BS EN 10346:2009 +G275.

View Complete Details

SET2 Safety End Strip Tie

A heavy duty safety tie designed for use in full fill cavities or where moisture travel across the tie is not an issue. Tested as type b (sound) and type 1 (strength) to bs en 845-1.

View Complete Details

TC Truss Clip

Truss clips provide an inexpensive and effective method of fixing trussed rafters to wallplates as recommended in bs 5268 : part 3. Manufactured from 1mm thick galvanised steel.

View Complete Details

SVM Soffit Vent Insect Mesh

Stainless Steel Soffit Vent Mesh is a fine 75mm wide mesh used over vents in soffits allowing air flow and preventing condensation, whilst also blocking access to birds and insects into the roof void.

View Complete Details

Tell Us What are you looking for? Will call you back

Contact Us

  • Flanshaw Way, United Kingdom